Gasket and oil seal kit Partner 351 3+2

The Partner 351 gasket set with crankshaft oil seals is intended for disassembling and resealing the compatible chainsaw engine. These Winzor aftermarket parts are suitable for repair when damaged gaskets or hardened oil seals leak air and prevent the engine from maintaining the required crankcase pressure.

The crankcase of a two-stroke engine must be completely sealed. Otherwise the chainsaw may be difficult to start, run unevenly at idle, take revs slowly or lose power. Air leakage can also overly lean the fuel mixture and increase the risk of engine damage.

Suitable chainsaws

Kit fits:

Partner 351
Partner 350 with the same engine sealing system
Partner 352 with the same engine sealing system
Partner 370
Partner 390
Partner 420
Gasket comparison number
530069608
Number with spaces: 530 06 96-08

This number denotes the type of engine gaskets used in the Partner 351 engine family. The included crankshaft oil seals allow you to renew the most important engine sealing points.

The kit includes
Engine sealing gaskets
Crankshaft oil seals
Product information
Part type: engine gasket and crankshaft oil seal kit
Manufacturer: Winzor
Engine type: two-stroke petrol engine
Purpose: engine repair and crankcase sealing
Condition: new aftermarket spare parts
Gasket comparison number: 530069608

After disassembling the engine, do not reuse old gaskets. Before assembly, thoroughly clean sealing surfaces but do not damage aluminum parts. Install the oil seals straight and check the condition of the crankshaft surface.

After assembling the engine, it is recommended to check the crankcase sealing with pressure and vacuum testing. Only then adjust the carburetor. Before installation also compare the gasket shapes, oil seal dimensions and the 530069608 number with the removed parts.

You can find more compatible products in the Partner 351 spare parts category. A seal and bearing kit is also offered for bearing replacement.