Carburetor intake connector for Chinese trimmer \/ brushcutter BC415 (+gaskets, screws)

The BC415 carburetor connector is designed to replace a cracked, deformed or leaking intake connector of a Chinese brushcutter. This part connects the carburetor to the engine intake port and helps maintain a sealed path for the fuel and air mixture to the cylinder.

The new Winzor aftermarket kit includes the carburetor intake connector, matching sealing gaskets and mounting screws. The carburetor is not included in the kit.

BC415 carburetor connector compatibility

The kit is intended for:

BC415 brushcutters and trimmers
for 1E40F-5 two-stroke engines
for TL43 and CG430 type engines
Chinese brushcutters with the same type of connector
compatible 43 cm³ engines with the same mounting points

BC415 models most commonly use a single-cylinder, air-cooled 1E40F-5 two-stroke engine with a displacement of 42.7 cm³. Its fuel system uses a diaphragm carburetor. General engine specifications for this model can be compared in the BC415 technical specification.

The kit includes
Carburetor intake connector
Sealing gaskets
Mounting screws
When should the connector be replaced?

The carburetor connector is constantly exposed to engine heat and vibration. It can also be damaged when removing the carburetor or by overtightening the mounting screws. If the connector or the gaskets are damaged, extra air enters the engine which the carburetor does not account for.

Due to leaks in the intake system the engine may be hard to start, run unstable at idle, respond slowly to throttle, or lose power. A new connector and gaskets help restore a sealed intake path.

Product information
Part type: carburetor intake connector kit
Manufacturer: Winzor
Application: Chinese brushcutters and trimmers
Engine type: air-cooled two-stroke petrol engine
Engine family: BC415 \/ 1E40F-5 \/ TL43
Condition: new aftermarket replacement part
Carburetor included: no

Before installation, remove any remnants of old gaskets and clean the sealing surfaces. Install the gaskets in the correct orientation, press the connector without deforming it, and tighten the screws evenly.

Before ordering, compare the shape of the connector, mounting holes, intake port and gasket arrangement with the old part. You can find more related products in the Chinese brushcutter parts category. If you are also replacing the carburetor itself, choose the BC415 carburetor.