Brushcutter / trimmer ignition coil Oleo-Mac SP42 / 44 PRO

This Oleo-Mac Sparta ignition coil – a non-original ignition module designed for compatible Oleo-Mac Sparta 42 and Sparta 44 petrol brushcutters. It is intended to replace a damaged or malfunctioning coil that can cause a weak spark, difficulty starting the engine, or failure to start.

The ignition coil corresponds to part number 61250015CR, which is listed in catalogs for Sparta 42 and Sparta 44 family models. However, before ordering compare the number and the entire part construction with the old coil.

Compatible Oleo-Mac Brushcutters

Main compatible models:

Oleo-Mac Sparta 42
Oleo-Mac Sparta 44

The same OEM number is also indicated for certain related versions:

Oleo-Mac Sparta 42 S
Oleo-Mac Sparta 44 S
Oleo-Mac Sparta 44 FE

Part number:

61250015CR

Due to variations across different production periods, the coil housing, wire routing, mounting points, or electrical connectors may differ. Therefore, the model name alone is not sufficient to determine final compatibility.

Purpose of the Oleo-Mac Sparta ignition coil

The ignition coil generates the high voltage required by the spark plug. If the module fails, the following symptoms may occur:

No spark
Spark is weak or inconsistent
Engine is hard to start
Warm engine stalls
Engine runs intermittently

However, similar symptoms can also be caused by the spark plug, its cap, the wires, or the engine kill switch.

Before installation inspect the flywheel, magnets, the spark plug lead and electrical connectors. Also clean any dirt accumulated around the coil.

Attach the new module evenly and set the correct gap between the coil and the flywheel according to the technical specifications of the specific model. After mounting, rotate the engine by hand and make sure the flywheel does not touch the coil.

Finally, check the spark and start the brushcutter safely. You can find more suitable components in the Oleo-Mac brushcutters parts category.